How to add ATG Terminal Connect or Web Connect to a Facility
Learn how to enable remote ATG management in Titan Cloud.
Written by Jess Hamilton
Updated at July 27th, 2024
ATG Terminal Connect and Web Connect are similar features that allow users to remotely operate a facility's gauge.
Which feature a facility can use is dependent on the make and model of their ATG.
ATG Terminal Connect
ATG Terminal Connect Supported Gauges
ATG Terminal Connect is a terminal emulator that allows you to remotely run commands and retrieve responses from the facility's connected ATG.
This feature is available only for the following ATG models.
Franklin Fueling Systems
- ASi
- Model 5
- Model 550 (VR Mode)
- Model 608
- TS-1000
- TS-1000 (VR Mode)
- TS-1001
- TS-2001
- TS-750
- TS504
- TS504T
- TS508
- TS508T
Veeder Root
- TLS-2
- TLS-250
- TLS-300
- TLS-350
- TLS-450
Hectronic
- Optilevel Controller 104M Basic
- Optilevel Controller 104M Master
OPW
- Site Sentinel iSite
ATG Web Connect
Web Connect Supported Gauges
ATG Web Connect is an interface that allows you to remotely run commands and retrieve responses from the facility's connected ATG.
This feature is available only for the following ATG models.
Franklin Fueling Systems
- EVO 200
- EVO 400
- EVO 600
- Model 5000
- Model 5000 EVO
- Model 550
- Model 550 EVO
Veeder Root
- TLS-450
Once you know which feature to enable, the process to do so is simple. However, if you have not yet connected the ATG to the facility, this needs to be done first. Setup instructions can be found in this article.
Configure ATG Information
Navigate to the Facility Profile, and open the ATG Information tab.
Click the pencil icon at the top left of the ATG Installation section to open the editor window.
If the ATG is compatible with ATG Terminal Connect as listed above, select “Yes” in the dropdown under “Supports TLS-3xxx Console Connect.”
If the ATG is compatible with Web Connect as listed above, select “Yes” in the dropdown under “ATG has Web Console.”
Click Save to confirm and close the window.
Verify Success
Now, in the left-hand navigation menu you should see the feature you enabled under ATG Management. If the ATG has been set up for polling successfully, no further configuration should be needed to begin using the Terminal Connect or Web Connect ATG emulators.